ParkZone VisionAire BNF Manuel d'instructions télécharger pdf (Page 6)

1. Install the landing gear strut (A) with the wheels

raked forward as shown.

2. Install the cover (B) on the fuselage using 4

screws (C).

Disassemble in reverse order.

Horizon Hobby has always made RC sport, scale and unique aircraft with

the kind of performance experts appreciate. First used in Blade

ultra micro

ﬂ ybarless helicopters, MEMS sensor technology within the Artiﬁ cial Stability - 3

aXis (AS3X) System has been speciﬁ cally tuned for airplanes helping invisibly

correct for turbulence, torque and tip stalls.

Now the exclusive AS3X Stabilization system makes the leap from Ultra Micro

aircraft to high performance parkﬂ yers with the AR635 receiver. The preci-

sion and performance available from AS3X equipped Ultra Micro airplanes has

heralded a new era of performance, and with the AR635 that performance is

introduced for larger airplanes.

The outstanding control agility delivers an ultra smooth, locked-in feel that

obeys your every command with performance that’s natural feeling. It’s so

gratifying, in fact, that it’s as though you’re the RC pilot of an expertly tuned,

giant-scale aircraft. Welcome to AS3X, your parkﬂ yer will never be the same!

To see what we mean, go to www.E-ﬂ iteRC.com/AS3X.

AS3X System

Arming the ESC and Receiver

Installing Landing Gear

Arming the ESC also occurs after binding as previously described, but

subsequent connection of a ﬂ ight battery requires the steps below.

AS3X

The AS3X system will not activate until the throttle stick or trim is increased for

the ﬁ rst time. Once the AS3X is active, the control surfaces may move rapidly

on the aircraft. This is normal. AS3X will remain active until the battery is

disconnected.

NOTICE: Due to increased servo power demands, only use the 40-Amp Lite Pro

Switch-Mode BEC Brushless ESC (EFLA1040LB V2) with the AR635. Use of any

other ESC presently available may result in damage to the aircraft.

1. Lower the throttle and throttle trim to lowest settings. Power on the

Transmitter, then wait 5 seconds.

2. Remove the battery hatch and install the ﬂ ight battery to the hook and

loop strip, then connect the battery to the ESC, noting proper polarity.

Keep the aircraft immobile on its wheels away from wind for

5 seconds. If the ESC sounds a continuous double beep after

the ﬂ ight battery is connected, recharge or replace the battery.

DO NOT connect the battery while the throttle stick is at full or the ESC will go

into programming mode.

If a musical tone sounds after 5 seconds, immediately disconnect the battery,

then lower the throttle.

Refer to the ESC manual (available separately) for more information.

3. When power is applied to the ESC:

1) The ESC will sound a series of tones (refer to step 4 of the

binding instructions for more information).

2) An LED will light on the receiver (the red, blue and green gain

LEDs will also ﬂ ash).

For further explanation of the gain lights, refer to the “Initializing the AR635”

section of the AR635 receiver manual.

CAUTION: Always

keep hands away from

the propeller. When

armed, the motor will turn

the propeller in response

to any throttle movement.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

ParkZone VisionAire BNF Manuel d'instructions Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Jouets télécommandés ParkZone VisionAire BNF